Plantronics cs50 headset instruction manual. PLANTRONICS CS55 USER MANUAL Pdf Download. 2019-01-13

Plantronics cs50 headset instruction manual Rating: 6,8/10 1685 reviews

CS50 Setup and Support

plantronics cs50 headset instruction manual

Press the talk button again. To clean the headset, remove the headset from the attachment and wipe clean. There are notches to the right of this dial. You can do this by unplugging at the wall or the bottom of the base as pictured. When talk time decreases significantly, you should replace the battery.

Next

Plantronics CS540 with HL10 Lifter Setup Instructions.

plantronics cs50 headset instruction manual

However, if you wish to use a replacement headset with the base unit, then the units must be re-subscribed as follows: 5 sec. These limits are designed to provi Summary of the content on the page No. You can fine tune this setting with the Plus + and minus - buttons on the back of the base that are above and below the picture of the microphone. Three rapid beeps every 15 seconds indicates your mute is on. To end a call: Press the call control button to lower the handset lifter. Try the re-subscription process again.

Next

Plantronics CS50

plantronics cs50 headset instruction manual

Press the mute control once to turn it off. IntelliStand, and Sound Innovation are trademarks or registered trademarks of Plantronics, Inc. If you want to quickly view the content of pages found on the following pages of the manual, you can use them. Press both the talk button 14 and the mute control button 15 on the headset for 5 seconds. When talk time decreases significantly, you should replace the battery.

Next

PLANTRONICS CS50 USER MANUAL Pdf Download.

plantronics cs50 headset instruction manual

There is also a switch on the right hand side of the base which is your the IntelliStand feature. Verify that the lifter is located on top of the telephone speaker. A is the lowest and D is the highest setting. Position handset lifter under the handset on your phone. To perform the system reset, follow this procedure: 1.

Next

Plantronics CS540 with HL10 Lifter Setup Instructions.

plantronics cs50 headset instruction manual

This is a dark grey dial with a 1234 on it. Dial tone should sound through headset. Headset microphone boom aligned Align the headset boom incorrectly with your mouth Speak volume is too low Increa Summary of the content on the page No. Minor Adjust Major Adjust Rock the headset volume control back and Use listening volume major adjust forth to adjust listening volume in minor control on the back of the base for large incremental adjustments. IntelliStand, and Sound Innovation are trademarks or registered trademarks of Plantronics, Inc.

Next

Plantronics CS50

plantronics cs50 headset instruction manual

Possible Cause Solution Incorrect softphone selected Ensure you have selected the softphone you are using through the software. Summary of the content on the page No. This device must accept any interference received, including interference that may cause undesired operation. May be required for technical assistance. Repeat step 4 until you have sufficient lift to give you dial tone when pressing the headset call control button. Step 3 Push in down in the picture and hold the black mute button for a minimum of 5 seconds The mute button is located at the end of the headset.

Next

Plantronics CS50

plantronics cs50 headset instruction manual

Voir sélectionné est aligné avec l'indicateur de position. This is the rocker volume wheel on the back of the headset opposite of the microphone. In addi- tion, the Status indicator 12 will flash rapidly. This feature is not available with all softphones. The system reset operation is complete. To end the call, replace the headset in the charging cradle or press the Talk button 3.


Next

PLANTRONICS CS50

plantronics cs50 headset instruction manual

Press the talk button on the headset to answer the all. Do not use solvents or other cleaning agents. Major Adjustment Minor Adjustment Affinement du réglage Réglage principal. To retrieve it from hold, press flash again. On older phones that require pushing a button to take a call, you will need to be at your phone to push the appropriate button and then you can walk away. Operation is subject to the following two conditions: 1.

Next